Applies To:

Show Versions Show Versions

Archived Manual Chapter: Configuration Examples
Manual Chapter
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

This article has been archived, and is no longer maintained.

Figure B.1 shows an example of a basic point-to-point configuration of WANJet appliances.
Figure B.2 shows an example of a mesh configuration including three WANJet appliances.
Figure B.2 Mesh configuration
WANJet2 and WANJet3 are remote WANJet appliances on WANJet1; WANJet1 and WANJet3 are remote WANJet appliances on WANJet2; and WANJet1 and WANJet2 are remote WANJet appliances on WANJet3.
WANJet1 sends optimized data to WANJet2 and WANJet3; WANJet2 sends optimized data to WANJet1 and WANJet3; and WANJet3 sends optimized data to WANJet1 and WANJet2.
Remote WANJet appliance 1
Figure B.3 shows an example of a hub and spoke configuration.
LAN1 connects to LAN2 and LAN3, and LAN2 and LAN3 connect to LAN1, but LAN2 and LAN3 do not connect to each other.
WANJet2 and WANJet3 are remote WANJet appliances on WANJet1; WANJet1 is a remote WANJet appliance on both WANJet2 and WANJet3.
WANJet1 sends optimized data to both WANJet2 and WANJet3, WANJet2 sends optimized data to WANJet1 only, and WANJet3 sends optimized data to WANJet1 only.
Figure B.4 shows an example of a redundant system configuration.
Two LANs are connected, and one of the LANs has WANJet appliances installed in a redundant system configuration.
LAN1 includes two WANJet appliances, WANJet1A and WANJet1B, and LAN2 includes WANJet2. WANJet1B is the redundant peer of WANJet1A. In case of router or WANJet appliance failure, the other router and its corresponding WANJet appliance resume functioning.
WANJet1B processes the half of the data in LAN1, and WANJet1B processes the other half of the data in LAN1 (load balancing).
Figure B.5 shows an example of a LAN router configuration.
A LAN router connects two networks to a WANJet appliance, and the WANJet appliance connects to the outside WAN through another router (WAN gateway).
LAN1 comprises three networks VLAN 100, VLAN 200, and WANJet1s network (192.168.1.0/24). The LAN router connects all three networks. You configure the LAN router on WANJet1.
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Was this resource helpful in solving your issue?




NOTE: Please do not provide personal information.



Incorrect answer. Please try again: Please enter the words to the right: Please enter the numbers you hear:

Additional Comments (optional)