After you have reviewed the hardware requirements and become familiar with the EM 4000 platform, you can install the unit.
The EM 4000 platform comes with two types of rack mounting kits: stationary front-mounting and sliding rail-mounting. An advantage of installing the sliding rail-mounting kit is that you can then slide the unit in and out of the rack as needed.
The tasks required to install the platform differ depending on the type of rack mount you decide to use or which type of cabinet unit you are installing into (single two-post cabinet or four-post cabinet).
Although not required, a 1U space between units makes it easier for you to remove the unit from the rack if that the unit requires service. A 1U space between units also provides additional cable routing options.
Leaving at least 100 mm spacing from the front panel of the unit to the rack front or rack door provides enough room for you to route the cables without excessive bending or insulation damage.
A shelf or similar device is required to support the unit if only one person is installing the unit.
You can use the front-mounting kit if you are installing into a two-post rack.
The front-mounting kit includes these parts.
|4||#6-32 pan head screws|
Use the rail-mounting kit if you want to be able to slide the unit in or out of the rack for maintenance activities.
The rail-mounting kit includes these parts.
|1||pair of rails (left and right)|
|4||mounting brackets (two front and two rear)|
|1||pair of rail lock brackets|
|8||#8-32 thumb screws|
|8||#8-32 Keps nuts or wing nuts|
|4||#6-32 pan head screws|
|2||#8-32 pan head screws (for rail locks)|
You should ground the platform after you install it in a rack. The chassis ground lug is located on the back of the platform.
Do not secure multiple bonding or grounding connectors with the same bolt. The grounding connectors do not need to be removed to perform service or installation procedures. You can connect other bonding or grounding conductors to a grounding connector provided a reliable bond between the connector and the equipment is not disturbed during installation, service, or maintenance of the platform.
After you have installed the unit into the rack, connect the cables and other hardware.
You can now assign a management IP address to the system, and then license and provision the software.
Optionally, you should run the latest version of the qkview utility. This utility collects configuration and diagnostic information about your system into a single file that you can provide to F5 Technical Support to aid in troubleshooting. For more information, see http://support.f5.com/kb/en-us/solutions/public/1000/800/sol1858.html.