Applies To:

Show Versions Show Versions

Manual Chapter: Best Practices
Manual Chapter
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Best Practices

vCMP best practices

F5 Networks makes the following recommendations for managing a vCMP® system.

Category Recommendation
vCMP® disk management Ensure that you allocate enough disk space for other installation slots for the vCMP host before you provision the vCMP feature.
Network setup Before setting up a vCMP system, verify that each slot's management interface is physically wired to an external bridge.
Slot assignment to guests Whenever possible, configure a guest to run on more slots than are actually populated with blades. The result is an automatic expansion of the guest cluster when you insert an additional blade.
Virtual disk management To prevent unattached virtual disks from consuming disk space over time, consider deleting unwanted virtual disks from the system. Otherwise, previously provisioned virtual disks remain on disk after their associated vCMP guest configurations have been deleted.
Protection from performance degradation To protect a guest from performance degradation if a blade failure occurs, configure high availability if possible. You do this by setting up device service clustering (DSC®). For a standalone vCMP system, consider deploying guests with sufficient cores and slots to ensure that a single blade failure does not result in unacceptable service degradation.
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Was this resource helpful in solving your issue?




NOTE: Please do not provide personal information.



Incorrect answer. Please try again: Please enter the words to the right: Please enter the numbers you hear:

Additional Comments (optional)