When setting up the BIG-IP® system to process application data, you might want the destination server to authenticate the client system directly, for security reasons, instead of relying on the BIG-IP system to perform this function. Retaining direct client-server authentication provides full transparency between the client and server systems, and grants the server final authority to allow or deny client access.
The feature that makes it possible for this direct client-server authentication is known as Proxy SSL. You enable this feature when you configure the Client SSL and Server SSL profiles.
Without the Proxy SSL feature enabled, the BIG-IP system establishes separate client-side and server-side SSL connections and then manages the initial authentication of both the client and server systems.
With the Proxy SSL feature, the BIG-IP system makes it possible for direct client-server authentication by establishing a secure SSL tunnel between the client and server systems and then forwarding the SSL handshake messages from the client to the server and vice versa. After the client and server successfully authenticate each other, the BIG-IP system uses the tunnel to decrypt the application data and intelligently manipulate (optimize) the data as needed.
To implement direct client-to-server SSL authentication, as well as application data manipulation, you perform a few basic configuration tasks. Note that you must create both a Client SSL and a Server SSL profile, and enable the Proxy SSL feature in both profiles.
Before you begin, verify that the client system, server system, and BIG-IP® system contain the appropriate SSL certificates for mutual authentication.
As you configure your network for Proxy SSL, keep in mind the following considerations:
You perform this task to create a Client SSL profile that makes it possible for direct client-server authentication while still allowing the BIG-IP system to perform data optimization, such as decryption and encryption. This profile applies to client-side SSL traffic only.
After you complete the tasks in this implementation, the BIG-IP® system ensures that the client system and server system can initially authenticate each other directly. After client-server authentication, the BIG-IP system can intelligently decrypt and manipulate the application data according to the configuration settings in the profiles assigned to the virtual server.