Applies To:

Show Versions Show Versions

Manual Chapter: Load Balancing to IPv6 Nodes
Manual Chapter
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Overview: Load balancing to iPv6 nodes

To set up the BIG-IP system to function as an IPv4-to-IPv6 gateway, you create a load balancing pool consisting of members that represent IPv6 nodes. You also create a virtual server that load balances traffic to those pool members.

As an option, you can use the tmsh command line interface to configure the BIG-IP system to send out ICMPv6 routing advisory messages, and to respond to ICMPv6 route solicitation messages. When you perform this task, the BIG-IP system begins to support auto-configuration of downstream nodes. Also, the downstream nodes automatically discover that the BIG-IP system is their router.

Task summary

When you configure IPv4-to-IPv6 load balancing, you must create a pool for load balancing traffic to IPv6 nodes, and then create an IPv4 virtual server that processes application traffic.

Task list

Creating a load balancing pool

The first task in configuring IPv4-to-IPv6 load balancing is to create a pool to load balance connections to IPv6 nodes. Use the Configuration utility to create this pool.
  1. On the Main tab, click Local Traffic > Pools. The Pool List screen opens.
  2. Click Create. The New Pool screen opens.
  3. In the Name field, type a unique name for the pool.
  4. For the Health Monitors setting, in the Available list, select a monitor type, and click << to move the monitor to the Active list.
    Tip: Hold the Shift or Ctrl key to select more than one monitor at a time.
  5. From the Load Balancing Method list, select how the system distributes traffic to members of this pool. The default is Round Robin.
  6. For the Priority Group Activation setting, specify how to handle priority groups:
    • Select Disabled to disable priority groups. This is the default option.
    • Select Less than, and in the Available Members field type the minimum number of members that must remain available in each priority group in order for traffic to remain confined to that group.
  7. Using the New Members setting, add each resource that you want to include in the pool:
    1. Type an IP address in the Address field.
    2. Type a port number in the Service Port field, or select a service name from the list.
    3. To specify a priority group, type a priority number in the Priority Group Activation field.
    4. Click Add.
  8. Click Finished.
The load balancing pool appears in the Pools list.

Creating a virtual server for IPv6 nodes

You can define a virtual server that references the pool of IPv6 nodes.
  1. On the Main tab, click Local Traffic > Virtual Servers. The Virtual Server List screen opens.
  2. Click the Create button. The New Virtual Server screen opens.
  3. In the Name field, type a unique name for the virtual server.
  4. For the Destination setting, in the Address field, type the IP address you want to use for the virtual server. The IP address you type must be available and not in the loopback network.
  5. In the Service Port field, type a port number or select a service name from the Service Port list.
  6. In the Resources area of the screen, from the Default Pool list, select the name of the pool that contains the IPv6 servers.
  7. Click Finished.
The virtual server that references the pool of IPv6 nodes appears in the Virtual Servers list.
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Was this resource helpful in solving your issue?




NOTE: Please do not provide personal information.



Incorrect answer. Please try again: Please enter the words to the right: Please enter the numbers you hear:

Additional Comments (optional)