Applies To:

Show Versions Show Versions

Manual Chapter: Tips for Standalone View Client and Dynamic Webtop Integration
Manual Chapter
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Example access policy for standalone View Client and View on webtop

You can configure one access policy that can provide access to a standalone View Client and can launch View from a webtop depending on the client type.

Client Type action branch rules

Place actions for the standalone View Client on the VMware View branch, and place actions for launching View from a dynamic webtop on the Full or Mobile Browser branch.

View desktop and Logon Page action; View client and VMware View Logon actio

Example access policy continued: Logon and authentication

To support a standalone View Client, you must provide a VMware View Logon page and Active Directory authentication. This example shows RSA SecurID authentication followed by Active Directory (AD) authentication. (SecurID authentication is optional for a standalone View Client. It can precede or follow AD authentication.)

To support launching View from a webtop, you can provide a Logon Page and any authentication type. This example includes AD Auth.

Logon and authentication actions on each branch

Example access policy completed: Resource assignment

After successful authentication, assign resources to the session.

Logon and authentication actions on each branch
Note: You might choose to configure your access policy differently. For example, you might not use SecurID authentication for a standalone View Client at all, and you might choose a different type of authentication, or multiple types of authentication, before launching View from a webtop.

About a configuration for standalone View Client and View on webtop

When you configure Access Policy Manager (APM) to support standalone View Client authentication and to support launching View from a dynamic webtop, the instructions specify the same type of configuration objects for either case. You can use the same objects for both cases if you begin the access policy with the Client Type action. Then configure actions for View Client authentication on the VMware View branch and configure actions for the webtop on the Full or Mobile Browser branch.

Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Was this resource helpful in solving your issue?




NOTE: Please do not provide personal information.



Incorrect answer. Please try again: Please enter the words to the right: Please enter the numbers you hear:

Additional Comments (optional)