Applies To:

Show Versions Show Versions

Archived Manual Chapter: Reviewing WANJet Appliance Messages
Manual Chapter
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

This article has been archived, and is no longer maintained.

Using the Configuration utility, you can display messages about events that have occurred on the WANJet appliance. You can view WAN optimization messages only, or TMOS-related messages as well as the WAN optimization messages.
1.
In the navigation pane, expand WAN Optimization and click Diagnostics.
2.
From the General menu, choose Diagnostic Log.
The Diagnostic log opens.
Refer to Table A.1, for general descriptions of the messages.
1.
In the navigation pane, expand System and click Logs.
The System log opens.
2.
On the menu bar, click Local Traffic or Audit to view additional logs.
Refer to Chapter 13, Logging WANJet Appliance System Events, for more details.
When events occur on the WANJet appliance, all messages are logged in the /var/log/ltm file. Table A.1 lists information about messages, such as errors, warnings, or diagnostic log messages, that relate specifically to WAN optimization.
If your company uses a centralized message server, you can configure the WANJet appliance to send messages to an associated SNMP server or Syslog server. Refer to Chapter 10, Configuring SNMP, for more information.
Connection reset: Source IP:Port <IP address:port #> Destination IP:Port <IP address:port #>
Description: The remote WANJet appliance was unable to connect to a server from the initiator IP address.
Error connecting to local client <Proxy IP> error (<error spec>)
Description: where <error spec> is a standard socket error. The local WANJet appliance was unable to connect to a server.
Connection (<server IP> <-> <client IP>) not optimized: SMB signing required (code 1219)
Warning: License key not entered - Bandwidth optimization off
or
Warning: License expired - Bandwidth optimization off
or
Warning: License invalid <reason> - Bandwidth optimization off
Warning: <#> days remain for evaluation license to expire
<SSL> certs invalid (error : <error>) - backing up to /tmp/certs_bak and recreating
Description: A problem occurred while starting the optimization service; the WANJet appliance was unable to become active.
Table of Contents   |   << Previous Chapter   |   Next Chapter >>

Was this resource helpful in solving your issue?




NOTE: Please do not provide personal information.



Incorrect answer. Please try again: Please enter the words to the right: Please enter the numbers you hear:

Additional Comments (optional)